Plain Mount

No mounting hardware provided. Customer to supply their own hardware for installation. Please note that mounting hardware or adhesive will be required to install letters. If you choose to do this yourself, and order without hardware as in one of the other options, please be sure of your capabilities. We can not be liable for damage done during installation.

Flush Stud Mount   Stud Mount Installation Instructions

3/16"diameter come out the back of each letter. Available on letters 3/8" thick or greater only. Pad mount is recommended for letters less than 3/8" thick An installation pattern will be required to ensure proper stud placement. Please be sure to order this with your sign letters. 10% additional cost for Flush Stud Mount

Pad Mount   Pad Mount Installation Instructions

Clear plastic pads - perforated plastic disks -   are glued into the backs of each letter.   You would apply clear silicone adhesive to the pad, and affix to the wall.   We recommend taping the letter up (6-12 hours) until the silicone has a chance to dry.

Stud / Spacer Mount Stud Mount Installation Instructions

Pre-cut spacers are inserted between the letter and the mounting surface on the stud. Specify by the amount of standoff required -- not by spacer length. Follows the same method as the flush stud mount. An installation pattern will be required to ensure proper stud placement. Available on letters 3/8" thick or greater only. Pad mount is recommended for letters less than 3/8" thick.

Semi-Adjustable Combination Mount   Stud Mount Installation Instructions

A combination mount differs from a stud mount in that the upper portion of the letter has studs and adjustable pads that can be screwed up or down the stud shaft based on the required depth.   The bottom portion of the letter will has non-adjustable pad mounts. This method is ideal for uneven surfaces. An {installation pattern} will be required to ensure proper stud placement. Available on letters 3/8" thick or greater only. Pad mount is recommended for letters less than 3/8" thick.

Fully-Adjustable Combination Mount   Stud Mount Installation Instructions

The difference between the Fully-Adjustable Combination Mount and Semi-Adjustable Combination Mount is that ALL studs have a pad that can be screwed up or down the stud shaft. This allows for full adjustability over all mounting points This is ideal for installations on corrugated tin, curved surfaces and other types of uneven surfaces. This method also provides the capability to stand off the letters from your mounting surface. An installation pattern will be required to ensure proper stud placement. Available on letters 3/8" thick or greater only. Pad mount is recommended for letters less than 3/8" thick